EasyManua.ls Logo

Daikin FTXN09NMVJU - Preparation Before Operation; Battery Installation and Remote Holder Mounting; Temperature Display Unit Switch; Circuit Breaker and Initial Setup

Daikin FTXN09NMVJU
26 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10English
2-2� Selection of copper and heat insulation materials
Whenusingcommercialcopperpipesandttings,observethefollowing:
• Insulationmaterial:Polyethylenefoam
Heattransferrate:0.041to0.052W/mK(0.024to0.030Btu/fth°F(0.035to
0.045kcal/mh°C))
BesuretouseinsulationthatisdesignedforusewithHVACSystems.
• ACRCopperonly.
Gas pipe
Liquid pipe
Gas pipe
insulation
Liquid pipe
insulation
Finishing tape
Drain hose
Inter-unit wire
• Besuretoinsulateboththegasandliquidpipingandobservetheinsulation
dimensionsasbelow.
Gas side
Piping size
O.D. 3/8 inch
(9.5mm)
O.D. 1/2 inch
(12.7mm)
O.D. 5/8 inch
(15.9mm)
O.D. 1/4 inch
(6.4mm)
1-3/16 inch (30mm)
or more
1-9/16 inch (40mm)
or more
1-15/16 inch (50mm)
or more
1-3/16 inch (30mm)
or more
0.031 inch (0.8mm)
(C1220T-O)
0.039 inch (1.0mm)
(C1220T-O)
0.031 inch (0.8mm)
(C1220T-O)
I.D. 15/32-19/32 inch
(12-15mm)
I.D. 9/16-5/8 inch
(14-16mm)
I.D. 5/8-13/16 inch
(16-20mm)
I.D. 5/16-13/32 inch
(8-10mm)
13/32 inch
(10mm) Min.
Minimum bend radius Piping thickness Thermal insulation size
Thermal insulation
thickness
Liquid side
• Useseparatethermalinsulationpipesforgasandliquidrefrigerantpipes.
Installation Tips
1 Removing and installing the front panel
• Removal method
1)Placeyourngersintheindentationsonthemainunit(oneeachon
theleftandrightsides),andopenthefrontpaneluntilitstops.
Indentations on
the main unit
2)Whilepushingtheleftsidefrontpanelshaftoutward,pushupthe
frontpanelandremoveit.(Removetherightsidefrontpanelshaftin
thesamemanner.)
3)Afterremovingbothfrontpanelshafts,pullthefrontpaneltoward
yourselfandremoveit.
Front panel shaft
• Installation method
Aligntheshaftofthefrontpanelwiththegroovesofgrill,andpush
allthewayin.Thencloseslowly.Pushthecenterofthelowerpanel
surfacermlytoengagethehooks.
English
01_EN_3P379970-1.indd 10 10/17/2014 12:57:25 PM

Other manuals for Daikin FTXN09NMVJU

Related product manuals