Daikin FTXS50K2V1B - Preparing for Operation; Remote Controller Setup; Display Brightness Adjustment

9
Preparation before Operation
■
To set the batteries
Position and
correctly!
+
–
2
3
1
1. Slide the front cover to take it off.
2. Set twodry batteries AAA.LR03 (alkaline).
3. Set the front cover as before.
■
To x the remote controller holder on the wall
Remote
controller holder
Remote controller
Screws
1. Choose a place from where the signals
reach the unit.
2. Fix the holder to a wall, a pillar, or similar
location with the screws procured locally.
3. Place the remote controller in the remote
controller holder.
■
To set the luminance of the display
•Theluminanceoftheindoorunitdisplaycanbeset.
Press .
Hi Low Off
NOTE
■
Notes on batteries
• Whenreplacingthebatteries,usebatteriesofthesametype,andreplacebotholdbatteriestogether.
• Whenthesystemisnotusedforalongtime,takethebatteriesout.
• Thebatterieswilllastforapprox.1year.Iftheremotecontrollerdisplaybeginstofadeandthedegradationofreceptionperformanceoccurs
withinayear,however,replacebothbatterieswithnew,sizeAAA.LR03(alkaline).
• Theattachedbatteriesareprovidedfortheinitialuseofthesystem.
Theusableperiodofthebatteriesmaybeshortdependingonthemanufactureddateoftheairconditioner.
■
Notes on remote controller
• Neverexposetheremotecontrollertodirectsunlight.
• Dustonthesignaltransmitterorreceiverwillreducethesensitivity.Wipeoffdustwithsoftcloth.
• Signalcommunicationmaybedisabledifanelectronic-starter-typeuorescentlamp(suchasinverter-typelamps)isintheroom.Consultthe
shopifthatisthecase.
• Iftheremotecontrollersignalshappentooperateanotherappliance,movethatappliancetosomewhereelse,orconsulttheserviceshop.
01_EN_3P320970-1A.indd 9 12/20/2012 11:22:05 AM