SiBE01-829 Instructions
Operation Manual 35
2.6 TIMER Operation
15
TIMER Operation
Timer functions are useful for automatically switching the air
conditioner on or off at night or in the morning. You can also
use OFF TIMER and ON TIMER in combination.
To use OFF TIMER operation
• Check that the clock is correct.
If not, set the clock to the present time. (page 9.)
1.
Press “OFF TIMER SET button” until the
indicated time reaches the point you like.
•
Every pressing of the button increases the time
setting by 30 minutes.
Holding down the button changes the setting rapidly.
• is displayed.
• The TIMER lamp lights up.
To cancel the OFF TIMER operation
2. Press “OFF TIMER CLR button”.
• The TIMER lamp goes off.
• disappears.
NOTE
To use ON TIMER operation
• Check that the clock is correct. If not, set the clock to the present time. (page 9.)
3.
Press “ON TIMER SET button” until the indicated time reaches the point you like.
• Every pressing of the button increased the time setting by 30 minuites.
Holding down the button changes the setting rapidly.
• is displayed.
• The TIMER lamp lights up.
To cancel the ON TIMER operation
4. Press “ON TIMER CLR button”.
• The TIMER lamp goes off.
• disappears.
ATTENTION
• Once you set ON, OFF TIMER, the time setting is kept in the memory.
•
When operating the unit via the ON/OFF Timer, the actual length of operation may vary from the time entered by the user.
In the following cases, set the timer again.
• After a breaker has turned OFF.
• After a power failure.
• After replacing batteries in the remote controller.
MODE
SLEEP
SET
CLR
ON TIMER
CLR
SET
OFF TIMER
OFF
ON
PM
AM
˚
C
û
F
AUTO
P1
P2
1
3
2
4
OFF
OFF
ON
ON
To Next Page
Loading...
Need help?
General
