Daikin FVXM35A3V1B User Manual

5 Operation
Operation manual
15
CVXM-A, FVXM-A, CVXM-A9, FVXM-A9, FVXTM-A
Split system air conditioners
3P477071-2M – 2022.09
INFORMATION
Scan the QR code to download and install the ONECTA
app on your mobile phone or tablet:
5.12.3 To set the wireless connection
There are two options to connect the wireless adapter with your
smart device.
▪ Connect the wireless LAN to your smart device directly.
▪ Connect the wireless LAN to your home network. The wireless
LAN will communicate with your smart device in your home
network using a modem, router or a similar device.
For more information and FAQ refer to app.daikineurope.com.
1 Stop operation before setting the wireless connection.
2 Use the wireless remote control to select the wireless LAN
setting menu.
Note: During setting, always aim the wireless remote control at the
infrared signal receiver on the unit.
Menu Description
Connection status check
WPS connection setting
AP mode/RUN mode (SSID + KEY) connection
setting
Reset to factory default
Wireless LAN OFF
To confirm the wireless LAN connection status
1 On the home screen, press for at least 5seconds while the
unit is not operating.
Result: SP appears on the display. is blinking.
(5 sec.)
2 Press to confirm the selection.
Result: is blinking.
3 Check the Daikin eye.
a
b
c
a Daikin eye
b Partly green
c Red, orange, blue or white
Daikin eye colour alternates
between partly green and…
…then wireless adapter is…
red not connected
Daikin eye colour alternates
between partly green and…
…then wireless adapter is…
orange running and ready to connect to
the home network via WPS
button; see "To connect using
the WPS button"[415].
blue ▪ connected to the home
network via SSID + KEY.
or
▪ connected to the home
network via WPS button on the
router.
white off
4 Press to exit the menu.
Result: The display will return to the home screen.
To connect the wireless LAN to your home
network
The wireless adapter can be connected to your home network using
the:
▪ WPS button (Wi-Fi Protected Setup) on the router (if present),
▪ The SSID (Service Set Identifier) and the KEY (password) -
located on the unit.
To connect using the WPS button
1 On the home screen, press for at least 5seconds while the
unit is not operating.
Result: SP appears on the display. is blinking.
2 Press to change the SP menu to .
(5 sec.)
1×
3 Press to confirm the selection.
Result: is blinking. The Daikin eye colour alternates between
orange and partly green.
4 Press the WPS button on your communication device (e.g.
router) within approximately 1 minute. Refer to the manual of
your communication device.
Result: If the connection was successful, the Daikin eye colour
alternates between blue and partly green.
INFORMATION
If the connection with your router is not possible, try
procedure "To connect using SSID and KEY
number"[415].
5 Press to exit the menu.
Result: The display will return to the home screen.
To connect using SSID and KEY number
1 On the home screen, press for at least 5seconds while the
unit is not operating.
Result: SP appears on the display. is blinking.
2 Press twice to change the SP menu to .

Daikin FVXM35A3V1B Specifications

General

Brand	Daikin
Model	FVXM35A3V1B
Category	Air Conditioner
Language	English