System Forced Stop
indication?
Is the indication System Forced Stop on the Monitoring screen, as
shown below?
This indication is shown in the following cases.
When forced stop command is input to central management
devices (central remote controller, ON / OFF controller, etc.)
including the intelligent Touch Controller, the indication appears.
Inputting forced command stops all air conditioners connected to
the central management device. While the command is input,
neither the central management devices nor remote controller can
operate air conditioners.
When the forced stop input command is canceled, the System
Forced Stop disappears, which allows control with the intelligent
Touch Controller.
Item Description and Corrective Action
Collective Operation, Start and
Stop buttons are not shown on
the Monitoring screen of the
intelligent Touch Controller and
operation of air conditioners is
made impossible.
Before Having the Product Serviced
102
Maintenance
To Next Page
Loading...
