Advanced Settings
26
English
Press to change the setting*.
Each press cycles between ON and OFF.
Lit up
ON
Unlit
OFF
Press
MODE
.
A short beep sounds, the FAN lamp
(Quiet) blinks, and the ECONO MODE
lamp changes to the following display
according to the setting.
Blinking
Blinking
ON
Unlit
OFF
While the lamp is blinking,
unplug the power supply plug,
wait at least 5 seconds, and
then insert the power supply
plug again.
Setting is now complete.
Power supply
plug
Power
socket
• If this procedure is not
performed, the unit will not
return to the regular operation
mode.
• Settings are remembered even
if the unit is unplugged.
Press
MODE
to change the setting*.
The airflow rate switches between 4 Levels
and 3 Levels with each press.
Unlit
4 Levels
Lit up
3 Levels
Press
.
A short beep sounds, AUTO FAN
MODE lamp blinks, and the FAN lamp
changes as below according to the new
setting.
Blinking
Unlit
4 Levels
Lit up
3 Levels
234
* If the lamps do not change even after the settings were changed, unplug the unit, wait at least 5 seconds, then re-insert the
power supply plug and repeat the above procedure from the beginning.
To Next Page
Loading...
