Daikin SiBE041010 - Page 123

SiBE041010 Indoor Unit
Removal Procedure 113
2
Disconnect the
connector [S27] from
the display PCB.
3
The figure shows the
names of the display
PCB component parts.
[S27]: control PCB
3. Remove the swing motor.
1
2
Release the harness
from the hooks.
Remove the screw of
the swing motor.
3
Disconnect the
connector.
Step Procedure Points
(R8010)
[S27]
ON/OFF button
(Forced operation ON/OFF button)
TIMER lamp
Signal receiver
Operation lamp
(R8035)
Swing motor