SiE12-411 Instruction
System Configuration 125
"
To operate the remote control
• To use the remote control, aim the transmitter at the indoor
unit. If there is anything to block signals between the unit
and the remote control, such as a curtain, the unit will not
operate.
• Do not drop the remote control. Do not get it wet.
• The maximum distance for communication is about 7 m.
"
To fix the remote control holder on the wall
1. Choose a place from where the signals reach the unit.
2. Fix the holder to a wall, a pillar, etc. with the screws
supplied with the holder.
3. Place the remote control in the remote control holder.
ATTENTION
Receiver
"
About remote control
• Never expose the remote control to direct sunlight.
• Dust on the signal transmitter or receiver will reduce the sensitivity. Wipe off dust with soft
cloth.
• Signal communication may be disabled if an electronic-starter-type fluorescent lamp (such as
inverter-type lamps) is in the room. Consult the shop if that is the case.
• If the remote control signals happen to operate another appliance, move that appliance to
somewhere else, or consult the shop.
Set.
To remove, pull it upwards.
Remote control
holder
To Next Page
Loading...
