SiE12-411 Instruction
System Configuration 137
2.9
HOME LEAVE Operation
Before using HOME LEAVE operation.
HOME LEAVE operation is a function which allows
you to record your preferred temperature and air
flow rate settings.
"
To start HOME LEAVE operation
1. Press “HOME LEAVE button” .
• The HOME LEAVE lamp lights up.
"
To cancel HOME LEAVE operation
2. Press “HOME LEAVE button” again.
• The HOME LEAVE lamp goes off.
C
TEMP
ON/OFF
POWERFUL
HOME LEAVE
MODE
TIMER
FAN
SWING
SILENT
SENSOR
ON
CANCEL
OFF
1, 2
ON
OFF
"
To set the temperature and air flow rate for HOME LEAVE operation
When using HOME LEAVE operation for the first time, please set the temperature and air flow
rate for HOME LEAVE operation. Record your preferred temperature and air flow rate.
1. Press “HOME LEAVE button”. Make sure
“”
is displayed in the remote control
display.
2. Adjust the set temperature with
“”
or
“”
as you like.
3. Adjust the air flow rate with “FAN” setting button as you like.
Home leave operation will run with these settings the next time you use this function. To change
the recorded information, repeat steps 1 – 3.
Initial setting Selectable range
temperature Air flow rate temperature Air flow rate
Cooling 25°C AUTO 18-32°C 5 step, AUTO and SILENT
Heating 25°C AUTO 10-30°C 5 step, AUTO and SILENT
To Next Page
Loading...
Need help?
General
