Test and Remove a Module
13
Remove a Module from the Top Row of a Section (Rear
Access)
Required Tools: 90-degree Allen wrench, module lanyard
To remove a module along the top row, complete the
following steps:
1� Using the procedure outlined in Remove a Module
(Rear Access) (p�12), remove the module in the
center of the bay directly below or at an angle of
the target module. Refer to Figure 19. All modules are
accessed from the rear through the center module.
2� Disconnect the power and SATA cables from the
module.
3� Connect a module lanyard from a lanyard
attachment ring on the module to a structural
member inside the display.
4� Insert the 90 degree Allen wrench into the top module
latch gear.
5� Turn a quarter-turn clockwise to disengage the module from the face sheet.
6� While holding the back of the module, insert the 90° Allen wrench into the bottom
module latch gear.
7� Turn a quarter-turn clockwise to disengage the module from the face sheet.
8� Remove the module by pushing it away from the
display face, pivoting and rotating it 90 degrees and
pulling it through the face sheet.
Note: Ensure louver blades run lengthwise when
pulling module through display face so they
are not damaged by the face sheet.
9� Repair or replace the module as needed.
10� Reverse Steps 1 - 8 to reinstall the module.
Remove a Module from Behind a
Term Panel (Rear Access)
Required Tools: Flat-head screwdriver,
1
/
8
" Allen wrench,
module lanyard
1� Turn the quarter-turn latch on the top-right side of the
term panel using a at-head screw driver. Refer to
Figure 20.
2� While holding the term panel, allow it to slowly rotate
open and out of the way. Refer to Figure 21.
3� Follow the steps in Remove a Module from the Top
Row of a Section (Rear Access) (p�13) to remove
and reinstall a module.
4� Reverse Steps 1 - 3 to replace the term panel.
Splice
Figure 19: Removing a Module
From Top Row of a Section
Figure 20: Term Panel Latch
Figure 21: Term Panel Swung Out
To Next Page
Loading...
