Daktronics 5000 Series - Hinge and Remove the DMP-8065 or Smartlink for Module Access

Test and Remove a Module
15
Hinge and Remove the DMP-8065 or SmartLink For
Module Access
The DMP-8065 hinges out of the way for module access. It
can also be lifted off the of the hinges. To hinge the DMP-
8065 out of the way and lift it off the hinges:
1� Locate the quarter-turn latch at the top of the DMP-
8065.
2� Use a athead screwdriver, turn the quarter-turn latch
counter-clockwise until the DMP-8065 disengages.
3� Pull the DMP-8065 from the right to hinge it out of the
way. Refer to Figure 24.
4� If needed, carefully lift the DMP-8065 off of the hinges
and set aside while ensuring power and signal cables
do not get pinched.
Figure 24: Hinge DMP-8065 Out
of Display