Daktronics 5000 Series - Control Equipment Overview, Service, and Replacement; Control Equipment Overview; ISP Enclosure; Dmp-8065

Control Equipment Overview, Service, and Replacement
19
7 Control Equipment Overview, Service, and
Replacement
Control Equipment Overview
ISP Enclosure
The ISP enclosure contains all of
the necessary equipment for the
display to communicate over the
Internet and schedule content.
Figure 32 shows the equipment and
the equipment location within the
ISP enclosure.
DMP-8065
The Digital Media Processor (DMP)
receives the content from the
Internet, sends it to the PLRs within
the display and to the modules. All
of the connections for the DMP are
located on the bottom of the unit. The DMP is a
eld replaceable unit. Refer to Figure 33.
SmartLink
TM
The SmartLink
TM
performs power loss detection and
remote power cycling for the 5000 series. Figure 37
shows the SmartLink
TM
conguration.
Open the ISP Enclosure
To access ISP box components, complete the
following steps:
1� Access the ISP enclosure by opening the rear
access door with the control
equipment label.
2� Using a athead screwdriver,
turn the two three-quarter turn
latches counterclockwise. Refer
to Figure 34.
3� For easier access to ISP
components, the ISP enclosure
door can be lifted off the
hinges.
Connect a Laptop
Sometime it is necessary to
connect a laptop to the display for
service. For displays without shared
internet, locate the red cross-over cable coming from out of port 5 of the network switch.
For displays with shared internet, disconnect the webcam from port 4 of the network
switch and connect a Cat-5 cable from port 4 to the laptop.
Fan
Z-Filter
Heater
120 VAC
Power
Receptacle
Ventilation Filter
Router
Ethernet
Switch
Thermostat
Door Switch
Figure 32: ISP Enclosure Layout
Figure 33: DMP-8065 Jacks
Turn
Latch
3/4
Hinges
Figure 34: ISP Enclosure Cover Removal