DF3000A(-DN) / DF3000AS(-DN)
14Dallmeier electronic
6 Installation and commissioning
6.1 Requirements at the installation site
The camera is designed for indoor use. If used outdoors, the camera has to be mounted
into a corresponding weather-proof housing.
Unfavorable local conditions may shorten the life of the product or lead to malfunctions.
Do not install/operate the camera in places:
z with large scale dust and dirt
z with steam or oil vapors (e.g. kitchen)
z with direct sunlight
z with improper ambient temperatures (see technical data)
z near sources of strong radiation (i.e. X-rays, radio transmitters or magnetic fields)
z with corrosive surroundings (e.g. gases or salt water).
6.2 Attaching the lens
M Lens
N Lens thread
IMPORTANT
Possible damage to the sensor.
The length of the lens thread plus any protruding parts must
not exceed 5 mm (L).
If using a C-mount lens, you have to screw a C-/CS-mount
adapter ring (5 mm) between the lens and the camera.
L = max. 5 mm
MN
Fig. 6-1
To Next Page
Loading...
