Two RJ 45 connectors are located on the left hand side panel of the
device. Both connectors are wired in parallel to allow different wiring
setups of the CAN-Bus
NOTICE: Shielded cables and shielded RJ 45 connectors must be used
to connect the devices of the d&b Remote network (CAN-Bus). The
cable shielding must be connected to both sides of the RJ 45 connector
as the "CAN Ground" is routed via the cable shielding.
RJ 45 [2] Pin Signal Remark
1 -
2 -
3 -
4 CAN_H
CAN high bus line (active high)
5 CAN_L
CAN low bus line (active low)
6
7
8
Shell GND
CAN ground
Table 2: RJ 45 (CAN-Bus) pin assignment
Page 8 of 20 R70 Ethernet to CAN interface, Manual
To Next Page
Loading...