Tension mode setup
13. The Splay link can be temporarily parked or, if it is the last
cabinet of the array, the Splay link can be stored in its Park
position ( ) and fixed using Locking pin [3].
14. With one person on each side, release the Locking pins at the
front of the cart.
15. Lower the cart and put it aside.
For the attachment of further touring cart assemblies, proceed in
the same manner.
5. Check the assembly
Before hoisting the array to its operating position, recheck the
actual status of the entire assembly according to the checklist given
in Þ Chapter 11 "Safety and system checks" on page 71.
d&b SL-Series Rigging manual 1.10 en 57
To Next Page
Loading...
