Need help?Do you have a question about the Danfoss Semco SEM-SAFE and is the answer not in the manual?
General| Water Source | Clean water, non-aggressive liquids |
|---|---|
| Power Supply | 380-480 VAC, 50/60 Hz (typically) |
| Protection Class | IP55 |
| Material | Stainless steel, cast iron |
| Weight | Varies depending on model (e.g., 150 kg to 600 kg) |
Comprehensive safety guidelines for operating and maintaining the SEM-SAFE® pump unit.
Information on copyright, liability, and Danfoss Semco's right to revise manual content.
An overview of the SEM-SAFE® High-Pressure Water Mist System and its types.
Detailed descriptions of Wet Pipe, Dry Pipe, Pre-action, and Deluge water mist systems.
Details various pump unit configurations, including tanks, manifolds, and pump types.
Description of electric motors, pilot pumps, unit tanks, and various manifolds.
Details valves, pressure controls, filter systems, and emergency back-up systems.
Overview of UCPs for Land, Marine, VdS, and FM Global applications.
Covers automatic/manual activation, increasing capacity, and shutdown procedures.
Steps to bring the SEM-SAFE® system back to a ready stand-by state after activation.
Details routine inspections and repairs for land units based on CEA 4001 standard.
Maintenance procedures and controls according to FM Global standards for SEM-SAFE® systems.
Outlines maintenance and inspection routines according to VdS Schadenverhütung.
Minimum maintenance and inspection levels for marine units as per MSC.1/Circ. 1432.
To Next Page