Danfoss Semco SEM-SAFE - Copyright, Liability, and Reservation Clauses

PAGE 8 / 48
END USER MANUAL
OPERATION AND MAINTENANCE OF HIGH PRESSURE WATER MIST PUMP UNIT
REVISION 4, MAY 2016
IMPORTANT. When the work is finished on the pump unit, the main switch
must be turned on again. If the main switch is not turned on, the SEM-SAFE
®
pump unit
will not activate if a fire occurs in the protected areas.
Personal Safety 1.1.4
a) Always use personal safety equipment (See chapter 1.1.5 Personal Safety Equipment).
Safety equipment will reduce personal injuries.
b) When replacing mechanical or electrical components on the pump unit, the main switch
should always be switched off. If this is not done, there will be an increased risk of injury.
IMPORTANT. When the work is finished on the pump unit, the main switch
must be turned on again. If the main switch is not turned on, the SEM-SAFE
®
pump unit
will not activate if a fire occurs in the protected areas.
Personal Safety Equipment 1.1.5
a) Persons staying in the area, during operation of the SEM-SAFE
®
pump unit must wear
hearing protection.
b) Persons who work with service and maintenance of SEM-SAFE
®
pump unit must wear hand
protection.
c) Persons who work with service and maintenance of SEM-SAFE
®
pump unit must wear
safety shoes.
Copyright, Confidentiality Statement and Trademark 1.2
This manual is the property of Danfoss Semco A/S, is confidential information and shall only be
used for carrying out operation and maintenance of the SEM-SAFE
®
High-Pressure Water Mist
Pump Unit. The manual shall not, in whole or in part, be reproduced, copied, disclosed or used as
the basis for manufacture, marketing or sale without the prior written permission of Danfoss Semco
A/S.