Introduction 1
Safety instructions for SEM-SAFE
®
pump unit 1.1
The SEM-SAFE
®
system is a high-pressure water mist system and consists of nozzles, pump unit,
section valves, piping system, etc. The SEM-SAFE
®
High-Pressure Water Mist Pump Unit and
system operates under high pressure and high voltage.
Care must be taken when operating the SEM-SAFE
®
High-Pressure Water Mist Pump Unit.
Installation, test, commissioning and service of the system is only to be carried out by appropriately
trained, competent personnel. It must be ensured that all relevant procedures are followed to the
satisfaction of the authority having jurisdiction, defined as organization, office, or individual
responsible for approving equipment, materials, an installation or a procedure.
General Safety instructions 1.1.1
WARNING
Read all safety instructions and instructions.
If the safety instructions and the instructions are not followed, there is a risk of electric shock and /
or serious injury.
Save all warnings and instructions for future use.
Workplace Safety 1.1.2
a) Make sure to keep the area around the pump unit free and clean. Disorder in the work area
increases the risk of accidents.
b) Make sure that other people and especially children are kept away from the pump unit when
the pump unit is operating.
Electrical Safety 1.1.3
a) The SEM-SAFE
®
pump unit is always connected to high voltage during standby and
operation.
b) The door on the Unit Control Panel should never be opened by anyone other than educated /
trained personnel as there is an increased risk of electric shock.
c) The main switch should always be switched off during replacement of electrical
components. If the main switch is not switched off there will be an increased risk of
electrical shock.
To Next Page
Loading...