Danfoss 103E5 - Programming 5;2 Day Mode (Weekdays); Programming 5;2 Day Mode (Weekends)

17
Programming event times in 5/2 day mode
You can programme your timeswitch to come on and go of up
to 3 times each day, to suit your requirements, with one set of
programmes for weekdays and a dierent set of programmes for
the weekend.
Weekdays (MOTUWETHFR)
o Press PROGRAMME until 1 (Event 1)
shows along the top of the display
and MOTUWETHFR shows along
the bottom.
o Use the + and - buttons to set the time you want your
system to rst come on in the morning.
o Press PROGRAMME again to move to Event 2
o Use the + and - buttons to set the time you want your
system to rst go o.
o Continue using the PROGRAMME and +/- buttons in this
way to set the ON/OFF times for events 3-6 for weekdays.
Weekend (SASU)
o Press PROGRAMME again until 1
(Event 1) shows along the top of the
display and SASU shows along the
bottom of the display.
o Use the PROGRAMME and +/- buttons to set the ON/OFF
times for the weekend.
If at any time you wish to return to the factory preset
programme, press SELECT / ADVANCE / + / - buttons together
at the same time to reset the unit.
N.B. It is not possible to programme times out of sequence.
Programming the unit - 5/2 day mode
1