GB
Danfoss Heating
9
Please Note
The unit must be programmed in sequence - ON/OFF times cannot
be set out of sequence.
If you want to leave a preset time as it is, simply press NEXT ON/OFF
to move on to the next setting.
Your clock will allow you to programme 3 ON/OFF settings per
day. If you do not wish to use one of the ON/OFF settings, simply
programme the ON time to be the same as the OFF time and the
setting will not operate.
If at any time you get confused and need to reset your timings to the
standard preset programme, press the R/S button to return to the
preset programmes.
!
3.3 Programming the Heating and Hot Water
in 7-Day Mode
1. Press PROGRAMME until SET ON
TIME appears at the top of the
display and press DAY until MO
appears at the bottom of the display.
Use the + and - buttons to set the
time you want your heating to rst
come on in the morning (Event 1).
2. Press NEXT ON/OFF to move to
Event 2.
Either press COPY to use the
same settings as the day before or
continue to programme the central
heating ON and OFF times, using the
+ and - buttons to set the time you
want and pressing the NEXT ON/OFF
button to move to the next setting.
PROGRAMME
NEXT/ON/OFF
+
-
DA Y
COPY
PROGRAMME
NEXT/ON/OFF
+
-
DA Y
COPY
PROGRAMME
NEXT/ON/OFF
+
-
DA Y
COPY
~--,,,-~-,
SET
ON
TIME
J-
f
1
'111
Rf'f
:
O·
Jlf
MO
■
To Next Page
Loading...
Need help?
General
