8 Menu operation RC8CC202 © Danfoss 09/2012 AK-LM 330 Vers. 1.4x
DE-DB
AKS 32 -20 dened with setting = 10
AKS 32 -34 dened with setting = 13
AKS 32 -50 dened with setting = 16
AKS 32R -6 dened with setting = 2
AKS 32R -9 dened with setting = 5
AKS 32R -12 dened with setting = 8
AKS 32R -20 dened with setting = 11
AKS 32R -34 dened with setting = 14
AKS 32R - 50 dened with setting = 17
AKS 2050 -59 dened with setting = 31
AKS 2050 -99 dened with setting = 32
AKS 2050 -159 dened with setting = 33
User-dened dened with setting = 0. + settings via Service Tool.
2 Do for Paux 2.
Alarm priorities
Measurements AK error When “ON”, the controller is in alarm condition.
Settings Main switch Main switch: ON: Regulation
OFF: Controller stopped
The alarm priority of the following alarms can be changed:
High priority is dened with setting = 1
Medium priority is dened with setting = 2
Low priority is dened with setting = 3
Overriding the alarms is dened with setting = 0
Stand by mode (Interrupted regulation) See the above introduction
Saux 1 error See the above introduction
2,3,4,5,6,7,8 As for Saux 1
Paux 1 error See the above introduction
2,3,4,5,6,7,8 As for Paux 1
DI1 See the above introduction
2,3,4,5,6,7,8 As for DI1
Th.1 High alarm See the above introduction
Th 1 Low alarm See the above introduction
2,3,4,5,6,7,8 As for Th. 1
P1 Low alarm See the above introduction
P1 High alarm See the above introduction
2 As for P1
V1 High alarm See the above introduction
V1 Low alarm See the above introduction
2 As for V1
Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products
already on order provided that such alternations can be made without subsequential changes being necessary in specications already agreed.
All trademarks in this material are property of the respecitve companies. Danfoss and Danfoss logotype are trademarks of Danfoss A/S. All rights reserved.