Danfoss D9h Installation Manual

9.3.9 AF Readouts 301-**
Par.
No. #
Parameter description Default value 4-set-up FC 302
only
Change
during
operation
Conver-
sion
index
Type
301-0* Output Currents
301-00 Output Current [A] 0.00 A All set-ups TRUE -2 Int32
301-01 Output Current [%] 0.0% All set-ups TRUE -1 Int32
301-1* Unit Performance
301-10 THD of Current [%] 0.0% All set-ups TRUE -1 Uint16
301-11 Estimated THD of Voltage [%] 0.0% All set-ups Uint16
301-12 Power Factor 0.00 N/A All set-ups TRUE -2 Uint16
301-13 Cos-phi 0.00 N/A All set-ups TRUE -2 Int16
301-14 Leftover Currents 0.0 A All set-ups TRUE -1 Uint32
301-2* Line Power Status
301-20 Line Power Current [A] 0 A All set-ups TRUE 0 Int32
301-21 Line Power Frequency 0 Hz All set-ups TRUE 0 Uint8
301-22 Fund. Line Power Current [A] 0 A All set-ups TRUE 0 Int32
Appendix A - Parameters Installation Manual
MG37A322 Danfoss A/S © Rev. 04/2015 All rights reserved. 119
9 9

Danfoss D9h Specifications

General

Brand	Danfoss
Model	D9h
Category	DC Drives
Language	English