High overload=150% or 160% torque for a duration of 60 s.
Normal overload=110% torque for a duration of 60 s.
Typical shaft output at 550 V [kW]
Typical shaft output at 575 V [hp]
Typical shaft output at 690 V [kW]
Continuous (at 550 V) [A]
Intermittent (60 s overload) (at 550 V) [A]
Continuous (at 575/690 V) [A]
Intermittent (60 s overload) (at 575/690 V) [A]
Continuous kVA (at 550 V) [kVA]
Continuous kVA (at 575 V) [kVA]
Continuous kVA (at 690 V) [kVA]
Continuous (at 525 V) [A]
Continuous (at 575/690 V) [A]
Maximum number and size of cables per phase
- Mains with disconnect [mm
2
(AWG)]
- Mains with fusible disconnect [mm
2
(AWG)]
- Mains with contactor [mm
2
(AWG)]
Drive module power loss at 600 V [W]
(1)(2)(3)
Drive module power loss at 690 V [W]
(1)(2)(3)
Heat sink overtemperature trip [°C (°F)]
Control card overtemperature trip [°C (°F)]
PHF overtemperature trip [°C (°F)]
AQ262139143212en-000301 / 130R0879 | 169Danfoss A/S © 2021.10
Specifications
VLT® AutomationDrive FC 302
Operating Guide
To Next Page
Loading...
Need help?
General