Danfoss ECL Comfort 100M User Manual

30
30
31
31
Check list
Is the ECL Comfort controller ready for use?
Make sure that the power supply is wired
correctly to the terminals 1 (Live) and 2 (Neutral).
See page 26.
Check the settings on the controller’s rear side.
See page 14:
Controller settings on the rear side.
Check that pumps and valves are connected to the
correct terminals.
See page 26:
Electrical connections
✐
Check list
Is the ECL Comfort controller ready for use?
Make sure that the power supply is wired
correctly to the terminals 1 (Live) and 2 (Neutral).
See page 26.
Check the settings on the controller’s rear side.
See page 14:
Controller settings on the rear side.
Check that pumps and valves are connected to the
correct terminals.
See page 26:
Electrical connections
✐
Check that all sensors are connected to the
correct ter mi nals.
See page 28:
Electrical connections - sensor
Mount the controller, switch on the power.
You can check the turning direction of the
motorized valve either by looking at it or by
feel ing whether the temperature of the actual pipe
chang es as expected.
The LED indicator shows whether the 100M is
operating or not. The indicator can also show
con trol status and faults when testing sensors and
controller.
See page 29:
LED indication
Check that all sensors are connected to the
correct ter mi nals.
See page 28:
Electrical connections - sensor
Mount the controller, switch on the power.
You can check the turning direction of the
motorized valve either by looking at it or by
feel ing whether the temperature of the actual pipe
chang es as expected.
The LED indicator shows whether the 100M is
operating or not. The indicator can also show
con trol status and faults when testing sensors and
controller.
See page 29:
LED indication

Danfoss ECL Comfort 100M Specifications

General

Brand	Danfoss
Model	ECL Comfort 100M
Category	Temperature Controller
Language	English