The circuit for heating the room/building.
All sensors used with the ECL Comfort controller is based on
the Pt 1000 ohm type. The resistance is 1000 ohms at 0 °C and
it changes with 3.9 ohms/degree C.
A period with decreased temperature.
A sensor placed in the room where the temperature is to be
controlled. The sensor is based on the Pt 1000 ohm type.
The temperature measured with the room sensor. The room
temperature can be controlled only when the sensor is
A facility that enables the controller to take the outdoor
temperature into consideration for heat ing con trol.
This control is based on a user defi nable heat curve which
determines what the fl ow temperature should be when the
outdoor temperature varies.
The temperature that is measured in the fl ow at any
A period of the day where comfort temperature is
The temperature maintained in the heating or hot water
circuits during comfort periods, which normally means
A facility which makes it possible to override the mode of the
The circuit for heating the room/building.
All sensors used with the ECL Comfort controller is based on
the Pt 1000 ohm type. The resistance is 1000 ohms at 0 °C and
it changes with 3.9 ohms/degree C.
A period with decreased temperature.
A sensor placed in the room where the temperature is to be
controlled. The sensor is based on the Pt 1000 ohm type.
The temperature measured with the room sensor. The room
temperature can be controlled only when the sensor is
A facility that enables the controller to take the outdoor
temperature into consideration for heat ing con trol.
This control is based on a user defi nable heat curve which
determines what the fl ow temperature should be when the
outdoor temperature varies.
The temperature that is measured in the fl ow at any
A period of the day where comfort temperature is
The temperature maintained in the heating or hot water
circuits during comfort periods, which normally means
A facility which makes it possible to override the mode of the
To Next Page
Loading...
Need help?
General
