Danfoss ECL Comfort 100M

14
14
15
15
Controller settings on the rear side
To make the controller ready for operation, you must
adjust the controller settings on the rear side.
Mini switches 1 to 8:
18 ˚C
Temp
Heating
Actual T
out
Accumulated T
out
Time
Heating OFF
Heating
The accumulated T
out
The accumulated T
out
The accumulated T
symbolizes the heat stored in the
build ing.
The heating cut-out function helps you save energy. Set the
limit for the outdoor temperature at which you want your
heat ing system to stop.
Set the acceptable min. limit of the fl ow temperature in your
heat ing system.
: Factory setting
Switch 2: Minimum fl ow temperature limit
Switch 2
Min. fl ow temperature
Your setting
OFF
10 ºC
ON
35 ºC
Switch 1: Heating cut-out
Switch 1
Cut-out temperature
Your setting
OFF
No cut-out
ON
18 ºC
Controller settings on the rear side
To make the controller ready for operation, you must
adjust the controller settings on the rear side.
Mini switches 1 to 8:
18 ˚C
Temp
Heating
Actual T
out
Accumulated T
out
Time
Heating OFF
Heating
The accumulated T
out
The accumulated T
out
The accumulated T
symbolizes the heat stored in the
build ing.
The heating cut-out function helps you save energy. Set the
limit for the outdoor temperature at which you want your
heat ing system to stop.
Set the acceptable min. limit of the fl ow temperature in your
heat ing system.
: Factory setting
Switch 2: Minimum fl ow temperature limit
Switch 2
Min. fl ow temperature
Your setting
OFF
10 ºC
ON
35 ºC
Switch 1: Heating cut-out
Switch 1
Cut-out temperature
Your setting
OFF
No cut-out
ON
18 ºC