Danfoss ECtemp Touch

Danfoss ECtemp Touch
17Installation Guide
If you break the small plastic seal
on the back of the display mod-
ule, e.g. using a screwdriver, it will
be possible to set the maximum
oor temperature up to 45°C.
Furthermore, it will be possible to
use only a room sensor. However,
this option is not recommendable due to an increased risk
of overheating the oor.
Important: When the thermostat is used to control a oor
heating element in connection with a wooden oor or
similar material, always use a oor sensor and never set the
maximum oor temperature to more than 35°C.
Note: Please contact the oor supplier before changing the
maximum oor temperature and be aware of the following:
• The oor temperature is measured where the sensor
is placed.
• The temperature of the bottom of a wooden oor can
be up to 10 degrees higher than the top.
• Floor manufactures often specify the max. tempera-
ture on the top surface of the oor.