Danfoss ECtemp Touch User Manual

Danfoss ECtemp Touch
9Installation Guide
3. Mount and reassemble the thermostat.
• Fasten the thermostat to a socket or an exterior wall
box by driving the screws through the holes in each
side of the thermostat.
• Put the frame on.
• Click the display module back in place.
Important: Do NOT press on the display screen when click-
ing the display module back in place.
Initially main supply the thermostat for 15 hours to fully
charge the battery. The current time and day is then kept
for 24 hours if mains supply is o. All other settings are
stored permanently.
3 Settings
3�1 Initial Settings
Initial settings must be specied when the unit is activated
for the rst time:

Danfoss ECtemp Touch Specifications

General

Temperature sensor	Yes
Control type	Touch
Product color	White
Memory function	-
International Protection (IP) code	IP21
Voltage	220 - 240 V
Power source	AC
Temperature control range	5 - 45 °C

Weight and Dimensions

Depth	24 mm
Package depth	140 mm
Package width	95 mm
Package height	85 mm
Package weight	24 g