Danfoss EM-PMI375 - Page 9

EM-PMI375-T800 options (continued)
Variant Code Description Additional information
Rotation sensor (resolver) * None No resolver
+RES1 Resolver In-built non contacting resolver, 6-pole
pair
+RES2 Double resolver 2 x In-built non contacting resolver, 6-pole
pair
Winding temperature
sensor
* Temperature surveillance 3 x PT100 in windings
+TEMP4 Redundant temperature
surveillance
6 x PT100 in windings
+TEMP5 Redundant temperature
surveillance
12 x PT100 (two wire) in windings (Not
available with +LVB1 option)
Bearing temperature
sensors
* None
+BTMP1 PT100 in bearings Plug-in connector
Anti-condensation heaters * None
+HEAT1 One anti-condensation
heater
230VAC/65W
Marine classification * No marine classification
+CL1 ABS American Bureau of Shipping
+CL2 BV Bureau Veritas
+CL3 DNV
+CL4 LR Lloyd’s Register
+CL5 RINA
EM-PMI375-T1100 options
Variant Code Description Additional information
High voltage connections * One 3 phase system One connection box containing one 3
phase system with one M25 cable gland
per phase
-DUAL Two galvanically isolated 3
phase systems
Two connection boxes each containing
one 3 phase system with one M25 cable
gland per phase
-TRI Three galvanically isolated
3 phase systems
Two connection boxes one containing one
3 phase system and another one
containing two 3 phase systems with one
M25 cable gland per phase
Low voltage connections * Low voltage connections
done with connector
DEUTSCH HD34-24-47PE connector for LV
connections
+LVB1 Low voltage connections
done with connection box
and terminal strip
Connection box with 2x M25 cable glands
(reserve 2x plugged M16 threads
available) and terminal block for LV
connections
N-end attachment * Flange SAE 4 flywheel housing
+NE2 Male shaft + Flange DIN5480 W50x2x24x8f + SAE 4 flywheel
housing
Bearing lubrication and
mounting direction
* Grease lubricated Deep groove ball bearing, open design.
Horizontal mounting direction.
+BGL Greased for life Deep groove ball bearing, contact seal on
both sides. Any mounting direction.
Maximum speed 3400 rpm.
User Guide
EM-PMI375
General information
©
Danfoss | November 2021 BC265856307805en-000202 | 9