Danfoss SH-E01 - Advanced Features; Power Failure Handling; Forced Cooling Operation; Regulator Fault Diagnosis

SHE01
6
3.3 Mounting Instructions
Install the regulator on a wall. Start by attaching the back plate to
a vertical fl at surface by means of 2 x Ø 4 mm screws. The terminals
must be at the top.
1
234
Position ON
Position OFF
Switch No.
System
Reset
Pump
Exercise
Setting
of start
temperature
diff erential
Switch No. Start temp.
diff erential
34
OFF OFF 5°C
OFF ON 10°C
ON OFF 15°C
ON ON 20°C
12
GB
D
DK
F
ES
PT