Do you have a question about the Danfoss TPOne-S and is the answer not in the manual?
Model | TPOne-S |
---|---|
Display | LCD |
Connectivity | Wired |
Temperature Range | 5°C to 35°C |
Power Supply | 230V AC |
Mounting | Wall-mounted |
Control Type | Digital |
Protection Class | IP30 |
Temperature Control Accuracy | ±0.5°C |
LCD Backlight | Yes |
Type | Room Thermostat |
Lists the technical specifications of the TPOne-S and DBR.
Emphasizes installation by qualified personnel and local regulations.
Guides on optimal placement for wireless communication and temperature sensing.
Illustrates wiring connections for the DBR receiver unit.
Shows the wiring diagram for the TPOne-S thermostat.
Explains how comfort modes simplify heating management.
Initial setup for controlling domestic hot water.
Steps for pairing the thermostat with the receiver via RF.
Configuring the WiFi connection for app pairing.
Configuring boost and mode for domestic hot water.
Connecting the TPOne-S to the internet for remote control.
Enabling or disabling domestic hot water control.
Pairing the thermostat with a compatible receiver.
Selecting the control type (On/Off or Chrono-Proportional).
Configuring the frost protection level to prevent damage.
Setting up reminders for boiler servicing.
Explains landlord responsibilities for boiler servicing and regulations.
Warning displayed when the RF connection to the receiver is lost.
Indicates a failure during the device pairing process.
Alerts to potential frost damage due to low temperatures.
Indicates that the set temperature is not being reached.
Alerts when the boiler service interval has expired.
Shows that heating is reduced pending boiler maintenance.
Warns if the internal temperature sensor is not functioning correctly.
Indicates the thermostat cannot find the home router.
Shows when the thermostat cannot obtain a valid IP address.
Alerts if the router is connected but lacks internet access.
Accessing RF pairing options within installer settings.