Need help?Do you have a question about the Danfoss TGH285 and is the answer not in the manual?
General| Type | Hermetic reciprocating compressor |
|---|---|
| Refrigerant | R134a |
| Frequency | 50Hz |
| Oil Type | POE oil |
| Connection Sizes | Suction: 1/2" SAE, Discharge: 3/8" SAE |
Explains the operation of the bearing control system and position feedback.
Step-by-step guide for installing the compressor I/O board onto a DIN rail.
Defines alarm and trip limits for discharge and suction pressures.
Specifies the trip settings for maximum discharge temperature.
Details the alarm and trip limits for suction pressure.
Covers FLA and LRA value ranges and their configuration.
Guidelines for protecting input power and electronic components.
Best practices for establishing proper grounding connections.
Chart showing operating limits for TTS300 and TGS230 models.
Operating envelope chart for medium temperature TTS300/TGS230.
Chart detailing operating limits for TTS350, TGS310, and TGS490.
Operating envelope chart for TTS400 and TGS390 models.
Chart showing operating limits for TTS700 and TGS520 models.
Operating envelope chart for TTH375 and TGH285 models.
Details the magnetic bearing system for shaft levitation and support.
Explains VFD use for capacity modulation and IGV integration.
Lists recommended torque values for various compressor fasteners and fittings.
Steps for inspecting the compressor for damage and reporting issues.
Guidelines for safely rigging and positioning the compressor.
Instructions for compressor placement and ensuring a level mounting base.
Steps for attaching suction, discharge, and motor cooling lines.
Details on connecting the interface cable to the compressor I/O board.
Describes the steps for connecting the power wiring to the compressor.
Provides a typical schematic for compressor electrical connections.
To Next Page