Need help?Do you have a question about the Danfoss TTH375 and is the answer not in the manual?
General| Operating temperature range | 0°C to +40°C |
|---|---|
| Electrical Connection | Screw terminals |
| Protection Class | IP30 |
| Housing Material | Plastic |
| Type | Thermostat |
| Application | Heating |
Provides a high-level overview of the compressor's control system and its major components.
Explains the magnetic bearing system for shaft support and its operational principles.
Offers guidelines for proper control wiring techniques and grounding.
Specifies the acceptable voltage and frequency ranges for compressor operation.
Explains configuration of current limits (FLA/LRA) and operating settings.
Addresses the need for fast-acting fuses for protecting power electronics.
Mandates the installation of a 5% impedance line reactor for each compressor.
Provides guidelines for proper grounding of electrical components and cables.
Explains how compressor performance is determined using specific software.
Details the magnetic bearing system used for shaft support and operation.
Explains the variable frequency drive and IGV usage for capacity modulation.
Outlines general requirements for system design and component selection.
Lists recommended torque values for various compressor components and fasteners.
Details procedures for unpacking, inspecting for damage, and reporting issues.
Guides on making suction, discharge, economizer, and motor-cooling connections.
Details the procedures for connecting the power wiring to the compressor terminals.
To Next Page