Danfoss TP5 - Customising TP5 Programmes (Weekdays)

18
For Days 1-5 (weekdays)
a) Press PROG 3 times to show the
1st pre-set time and temperature
(Event 1, MOTUWETHFR). Please
note MOTUWETHFR is the
abbreviation for the days of the
week.
b) Use + or – buttons to adjust the
TIME (press and hold to change in
10 min increments).
c) Use  or  buttons to adjust the
TEMPERATURE.
d) Press PROG to move to next preset
time & temperature (Event 2,
MOTUWETHFR).
e) Repeat steps b, c & d for
programming Events 3, 4, 5 & 6.
Changing the preset programmes - TP5
20
AM
MOTUWETHFR
User Instructions
GB