Danfoss TP5000 + RF User Manual

4
GB - Installation Instructions
Installation
 First, remove the wallplate from the back of the unit.
 From the top left hand corner of the wallplate, there must
be clearances of at least 140mm to the right, 15mm to
the left, 30mm above and 100mm below in order to
mount the plug-in module.
 Fix at a height of approximately 1.5m from the fl oor,
away from draughts or heat sources such as radiators.
open fi res or direct sunlight.
 Prior to mounting the unit should be set in either ON/
OFF or chrono-proportional control mode (see below).
1) ON/OFF - boiler switches ON when below set temperature
and OFF when above..
1) ON/OFF 2) CHRONO

Danfoss TP5000 + RF Specifications

General

Type	Programmable Room Thermostat
Display	LCD
Power Supply	2 x AA batteries
Radio Frequency	868 MHz
Frost Protection	Yes
Backlight	No
Communication	Wireless (RF)
Number of Programs	6 programs per day
Wireless Range	30 meters (indoors)
Temperature Control Accuracy	+/- 0.5°C
Programming	7-day or 5/2-day programming