Danfoss TP6000M - Page 4

4
BUTTONSLCD DISPLAYS
2. Press PROG to advance to temperature setting.
3. Press  or  buttons to adjust heating temperature
OPTIONAL: If heating is not required, “O ” can be selected below 5°C.
Press PROG button to move onto event 2 programming and follow details below.
1. Press + or – buttons to adjust event time.
2. Press PROG to advance to temperature setting.
3. Press  or  buttons to adjust heating temperature
OPTIONAL: If heating is not required, “O ” can be selected below 5°C.
Press PROG button to move onto next event 3 programming and follow details below:
1. Press + or – buttons to adjust event time.
2. Press PROG to advance to temperature setting.
3. Press  or  buttons to adjust heating temperature
OPTIONAL: If heating is not required, “O ” can be selected below 5°C.
Press PROG button to move onto next event 4 programming and repeat steps F1 – F3 above.
1. Press + or – buttons to adjust event time.
2. Press PROG to advance to temperature setting.
3. Press  or  buttons to adjust heating temperature
OPTIONAL: If heating is not required, “O ” can be selected below 5°C.
PROG


or
then


or
PROG
+
-
or
PROG
then
then


or
PROG
+
-
or
PROG
then
then


or
PROG
+
-
or
PROG
then
then