Danfoss VLT 6000 series - Mains Connection

VLT
®
5000/6000/8000 Series
■
Mains connection
Mains must be connected to terminals R/L1/91,
S/L2/9
2, T/L3/93.
NB!:
Check the name plate to ensure that the
mains voltage of the VLT frequency converter
matches the power supply of your plant.
Ensur
e that the power supply can supply
the necessary current to the VLT frequency
converter, see Technical data.
If the
unit is without built-in mains disconnector and
fuses, ensure that the appropriate disconnector or
fuses have the correct current rating.
See Technical data for correct sizing of
cable cross-sections.
See E
lectrical installation prodedures for how install
the mains connections to the VLT frequency converter.
Mains connection from the side without
built-in disconnector and fuses
Mains connection from the bottom without
built-in disconnector and fuses
Mains connection from the side with built-in
disconnector and fuses
MG.56.A2.02 - VLT is a registered Danfoss trademark
20