20-** Drive Closed Loop
20-0* Feedback
20-00 Feedback 1 Source
20-01 Feedback 1 Conversion
20-03 Feedback 2 Source
20-04 Feedback 2 Conversion
20-2* Feedback/Setpoint
20-20 Feedback Function
20-8* PI Basic Settings
20-81 PI Normal/ Inverse Control
20-83 PI Start Speed [Hz]
20-84 On Reference Bandwidth
20-9* PI Controller
20-91 PI Anti Windup
20-93 PI Proportional Gain
20-94 PI Integral Time
20-97 PI Feed Forward Factor
28-** Compressor Functions
28-0* Short Cycle Protection
28-00 Short Cycle Protection
28-01 Interval between Starts
28-02 Minimum Run Time
28-1* Oil Return Management
28-10 Oil Return Management
28-11 Low Speed Running Time
28-13 Boost Duration
28-15 ORM Min Speed Limit [Hz]
28-17 ORM Boost Speed [Hz]
28-4* Anti-reverse Protection at Stop
28-40 Reverse Protection Control
28-6* Compressor Readouts
28-60 RPS
Quick Guide Quick Guide
22 Danfoss A/S © Rev. 09/2014 All rights reserved. MG18M102
1
1
To Next Page
Loading...
