9-22 Telegram Selection
Option: Function:
Select a standard Profibus message configuration for the adjustable frequency drive as an alterna-
tive to using the freely configurable messages in par.9-15
PCD Write Configuration
and par.
9-16
PCD Read Configuration
.
[1] Standard telegram 1
[101] PPO 1
[102] PPO 2
[103] PPO 3
[104] PPO 4
[105] PPO 5
[106] PPO 6
[107] PPO 7
[108] * PPO 8
[200] Custom telegram 1
9-23 Parameters for Signals
Array [1000]
Option: Function:
This parameter contains a list of signals available for selection in par.9-15
PCD Write Configura-
tion
and par.9-16
PCD Read Configuration
.
[0] * None
[302] Minimum Reference
[303] Maximum Reference
[341] Ramp 1 Ramp-up Time
[342] Ramp 1 Ramp-down Time
[351] Ramp 2 Ramp-up Time
[352] Ramp 2 Ramp-down Time
[380] Jog Ramp Time
[381] Quick Stop Ramp Time
[411] Motor Speed Low Limit [RPM]
[413] Motor Speed High Limit [RPM]
[416] Torque Limit Motor Mode
[417] Torque Limit Generator Mode
[590] Digital & Relay Bus Control
[593] Pulse Out #27 Bus Control
[595] Pulse Out #29 Bus Control
[597] Pulse Out #X30/6 Bus Control
[653] Terminal 42 Output Bus Control
[663] Terminal X30/8 Output Bus Control
[890] Bus Jog 1 Speed
[891] Bus Jog 2 Speed
[894] Bus Feedback 1
[895] Bus Feedback 2
3 Parameter Description VLT
®
HVAC Drive Programming Guide
3-104
MG.11.C6.22 - VLT
®
is a registered Danfoss trademark
3
To Next Page
Loading...
