No
.
Description Warning Alarm Trip
Lock
Error Cause of Problem
92 Parameter value exceeds the
min/max limits
X Occurs when trying to set a value outside the range.
nw
run
Not While RUNning X Parameter can only be changed when the motor is stopped.
Err. An incorrect password was
entered
X Occurs when using an incorrect password for changing a
password-protected parameter.
1)
These faults may be caused by line power distortions. Installing a Danfoss line filter may rectify this problem.
Table 1.12 Warnings and Alarms Code List
Quick Guide
VLT
®
Micro Drive Quick Guide
MG02B722 - VLT
®
is a registered Danfoss trademark 1-15
1 1
To Next Page
Loading...
