Danfoss VLT Soft Starter MCD 600 - Connect to the Device via Web Server

1.
Procedure
Set parameter 1-1 Command Source to Network for the soft starter to accept commands from the EtherNet/IP Card.
4.5 On-board Web Server
4.5.1 Connect to the Device
To configure settings using the on-board web server, the EtherNet/IP Card must be installed in a soft starter, control power must be
available, and the card and computer must both be connected to the Ethernet network.
The computer must use a fixed IP address (not DHCP) and the same subnet mask as the card. The default IP address for the card is
192.168.0.2. The default subnet mask is 255.255.255.0.
e77ha807.10
Once connected, the web server reports basic information about the card and the soft starter.
MCD 600
e77ha812.10
AN353423548483en-000101 / 130R094510 | Danfoss A/S © 2020.12
Device Configuration
EtherNet/IP Card
Installation Guide