Danfoss VLT Soft Starter MCD 600 - Configure MQTT Settings

1.
2.
3.
4.
5.
6.
4.5.4.1 Configuring MQTT Settings
e77ha810.10
Procedure
Connect to the web server and click Configuration.
Select MQTT Client.
Tick the Enable checkbox to enable MQTT client operation.
The MQTT client is enabled by default.
Click Connection and configure the settings as required.
Click Connections⇒Actions to select which information the card should publish.
Click Submit to save all settings in the card.
AN353423548483en-000101 / 130R0945 | 13Danfoss A/S © 2020.12
Device Configuration
EtherNet/IP Card
Installation Guide