DANIEL 700 - Control Valve Handling; Receiving and Inspecting the Valve; Storing the Control Valve

25
www.Daniel.com
USER MANUAL
3 Control valve handling
3.1 Receive the control valve
WARNING
EQUIPMENT HANDLING AND OPERATING HAZARD
Wear personal protective equipment appropriate to the situation when working with
the control valve. Adhere to all safety standards and best practices for operating the
equipment.
Failure to comply may result in death or serious injury.
3.1.1 Unpack and inspect the control valve
Check the control valve when it is received at the customer facility.
Procedure
1. Remove the control valve from the shipping container.
2. Inspect the control valve for damage.
3. See Installation procedure.
3.2 Store the control valve
3.2.1 Rust inhibitor
Apply light oil or rust inhibitor on surfaces that are in contact with the environment.
3.2.2 Pack the control valve
Procedure
1. Use stretch wrap (not adhesive) to attach the correct size flange cover to the valve
end flanges. This protects the unpainted surfaces of the flange sealing.
2. A flush contact between the flange cover and the flange sealing face is important.
User manual Control valve handling
P/N 3-9008-553 November 2020
User manual 27