P I 02 9604 1226 E I sales@danielaappliances.com.au W | danielaappliances.com.au
PAGE 14
BEFORE USING FOR THE FIRST TIME
SETTING AND CHANGING THE CURRENT TIME
The oven only operates when the time has been set.
When the appliance is connected to the electrical supply or when there has been a power cut,
the symbol for Time flashes automatically.
• To change a time that has already been set, press the Clock function button
repeatedly until the symbol for Time flashes.
• Using the or button, set the current time. After about 5 seconds, the flashing
stops and the clock displays the time of day set.
The appliance is now ready for use.
GETTING TO KNOW THE APPLIANCE
The appliance can be operated in test mode for testing or performing all operating steps.
The oven will not heat up during the test.
SWITCHING ON THE TEST MODE
1. Switch o the appliance using the On/O button.
2. Press and hold and buttons at the same time until an acoustic signal is heard
and “d” lights up in the display.
SWITCHING OFF THE TEST MODE
1. Switch o the appliance using the On/O button.
2. Press and hold and buttons at the same time until an acoustic signal is heard
and “d” goes up in the display.
OPERATING OF OVEN
• The oven light is switched on as long as an oven function is started.
• The oven light is switches o when the appliance switched o automatically.
The oven light is switched on or gone o by pressing the and buttons in turn, within
approx. 2 seconds when the appliance is switched o.
• Switch appliance o using the On/O button.
To Next Page
Loading...
