Need help?Do you have a question about the Dansensor ISM-3 and is the answer not in the manual?
General| Brand | Dansensor |
|---|---|
| Model | ISM-3 |
| Category | Measuring Instruments |
| Language | English |
Advice for prolonging analyser life, calibration checks, and calibration intervals.
Procedure for powering on the ISM-3, including self-test and heating period.
Explanation of button functions and display behavior when parameters are shown.
How to start and stop the measurement process using the device buttons.
Methods for starting and stopping measurements using external signals or manual button presses.
Procedure for programming high and low oxygen alarm limits and relay activation.
How to display and monitor the sensor flow rate in ml/min.
Description of flow alarms, their priority, and display indications.
Overview of the three sub menus (Set-up, Diagnostic, Calibration) and how to access them.
Parameters and values available in the SET menu for configuration.
Parameters and values available in the DIR menu for diagnostics and status.
Reference to the calibration chapter for procedures within the CAL menu.
Configuring options, relay functions, and external measurement control via the PR parameter.
Step-by-step guide for calibrating the ISM-3 with atmospheric air and calibration gases.
Procedure for performing an offset adjustment using atmospheric air.
Configuration of current or voltage output signals for the ISM-3.
List of accessories included with the ISM-3 unit.
List of optional accessories available for purchase.
List of available options and their corresponding part numbers.
Technical details of the oxygen sensor, including type, temperature, and response time.
Description of the gas flow system, including pressure and flow rate limits.
Details on display, control, accuracy, measuring ranges, and possible connections.
Overall technical specifications including mains, consumption, dimensions, and weight.
To Next Page
