Warning
This installation manual and the product use various displays and labels to ensure safe use.
Failure to follow these instructions could result in injury, death or damage to equipment.
Ignoring these displays and labels and incorrectly using the product could have results as
classied below.
Please read the following warning symbol information before reading the rest of this section,
and be sure to strictly observe all instructions.
This product is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the product by a person responsible for
their safety.
Children should be supervised to ensure that they do not play with the product.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualied person in order to avoid a hazard.
Failure to follow these instructions could result in death or serious injury
Failure to follow these instructions could result in injury or property damage.
This symbol means something that should NOT be done
Project safety is your responsibility!
Follow the instructions in this manual regarding the installation method and installation
orientation. All work should be performed by qualied personal using safe work practices.
All proper personal protective equipment should be used. PPE required for this installation
includes, but is not limited to:
• Safety glasses
• Hard hat
• Safety shoes
• Hearing protection
• Cut resistant gloves
• Face shield
• Proper work attire (long sleeve shirt and long pants)
Please strictly observe the following: Special Skill is required to install the Dantherm products.
Non-qualied personnel should not attempt any of the actions shown in this installation
guide. Dantherm shall not be responsible for improper installation or any accidents, damage,
or injury resulting from improper installation.
Introduction
General precaution
4