en
it
de
es
fr
nl
pt
da
no
sv
pl
ru
cs
hu
sl
tr
hr
lt
lv
et
ro
sk
bg
uk
bs
el
zh
Refer to the “CONTROL PANEL” paragraph for
the operating modes.
►►2.1. REFRIGERANT CIRCUIT
The refrigerant gas used in these units is
R1234yf. The refrigerant circuit is built in com-
pliance with current standards.
Flammable material hazard.
This unit is hermetically sealed and contains
►►►3. PRELIMINARY OPERATIONS
►►3.1. REMOVAL OF THE PACKAG-
ING AND ASSEMBLY
(PIC. 3)
Remove the packaging taking care not to dam-
age the unit. Dispose of the packaging products
(wood, plastic, cardboard), taking them to the
specialised collection or recycling centres (fol-
low the local regulations in force).
CAUTION: Assemble the appliance, with the
adequate air outlet (1 or 2-way outlet, depend-
ing on the model), handles, wheels, cord reel
and all the relevant nuts and bolts, before oper-
ating it.
NOTE: Correct operation requires the appropri-
ate air outlet to be installed, according to the ac-
tual requirements (depending on the model).
►►3.2. INSPECTION
All units are factory assembled and wired
(except for certain components). Upon receiving
the unit, it must be immediately and thoroughly
inspected, checking that it has not been dam-
aged during transport or that no parts are miss-
ing.
on the external metal panels, including those in
the tank compartment. Also check that the ca-
ble, plug and relevant insulation are intact. Oth-
erwise, it is FORBIDDEN to connect and start
the unit, which must be sent to an authorised
service centre.
►►3.3. OPERATING PRINCIPLES
CAUTION: To ensure correct operation of
the appliance, it is recommended to operate
the unit within the limits shown on the tech-
nical data table.
►►3.4. POSITIONING
Set up the appliance to ensure an adequate air
CAUTION: Make sure that the appliance is
placed in such a way so as to prevent contact
with water.
►►3.5. SERVICE AREA
The hot air expelled by the fan must not be ob-
structed. Avoid recirculation phenomena of the
air expelled and drawn by the appliance so as
to prevent compromising the performance of the
unit or even interrupting normal operation.
CAUTION: The equipment must not be
placed in cramped environments, which do not
allow adequate distribution of the air from the
dedicated inlets and outlets in the room.
CAUTION: Do not place or hang objects on
the front panel, it may cause damage to the unit.
►►3.6. GENERAL INFORMATION
CAUTION: Disconnect the power plug from
the socket before carrying out any maintenance
operation on the electrical part.
CAUTION: Check that the supply voltage
corresponds to the unit's operating data (volt-
age and frequency) shown on the data plate on
power cable for correct operation.
CAUTION: The earthing connection is man-
datory.
To Next Page
Loading...
Need help?
General
