Dantherm CDT 30S MK III - Preparation and Transportation Guide; Introduction to Preparation and Transport; Handling Warnings and Unpacking

7
053326 • Version 1.0 •
13-12-2019
en
Preparation and transportation guide
Introduction
This section is a guide to unpacking, preparation, transport and storage
Warning
If the machine has been transported lying down, allow it to stand upright for at least 1
hour before use.
Unpacking
Follow these steps for unpacking:
Step
Action
Illustration
1
Open the top of the pack-
aging
2
Position the box vertically,
with the wheels at the bot-
tom
3
Extract the machine from
the box
4
Loosen the knobs, pull the
handle up to the desired
height and retighten the
knobs
5
Remove the protective foil on the control panel
Continued on next page