9
060804 • Version 1.6 • 22.01.2019
Fittings and installations, continued
Mounting the unit,
continued
*)
on the connection piece. The hose can be difficult
to connect to the connection piece. When the hose is about to be mounted it
can be helpful to warm up the hose prior to mounting, thereby it will be more
flexible to work with. Use lubricant on the hose if necessary, so that it can
smooth over the connection piece and maybe a hose clamp (not delivered)
*)
Drainage hose is not supplied. Use a 3/4" reinforced hose, which cannot be
broken or crushed flat. Dantherm recommends a transparent type with iron
wire, so it is possible to inspect the water trap
Lead the drainage hose through the ceiling construction and insulate up above
the hose connection piece:
Make sure that the drainage and drain pipe are always frost proof. A frozen
drain pipe can lead to damage. If it cannot be assured to keep the drainage
and drain pipe frost proof, Dantherm recommends connecting a heating cable
around the drain pipe. See more about this in the accessories list in the sec-
tion “Accessories” in the user’s guide.
Continued overleaf
To Next Page
Loading...
Need help?
General
