22
Removal &
Storage
Before storage, the earth auger should be thoroughly cleaned, washing o all dirt and grime.
Make sure the hydraulic system is properly sealed against contaminants entering the unit.
Always store the earth auger in a dry, covered location.
STEP 1:
STEP 2:
Lower the earth auger onto a at, level surface in an area where children do not
play.
Disconnect the hydraulic hoses from the vehicle's auxiliary hydraulics.
Connect the quick couplers together to prevent contaminants from entering the
drive unit's hydraulic system.
Follow your vehicle operator's manual for removing an attachment. Securely
block and support the attachment.
Tighten any loose nuts, bolts, and hydraulic components.
Replace any damaged or missing safety signs.
Before disconnecting hydraulic lines or fittings, be sure
to relieve all pressure by cycling all hydraulic controls
after shutdown. Remember hydraulic systems are under
pressure whenever the engine is running and may hold
pressure after shutdown.
Never allow anyone under
the attachment at any
time.
STEP 3:
STEP 4:
STEP 5:
Because of the weight of
some components, and
because some
components are difficult
to balance, two people
are required for safe
assembly and installation
of this equipment.
Personal protection
equipment including
hard hat, safety glasses,
safety shoes, and gloves
are recommended during
assembly, installation,
operation, maintenance,
service, removal, or
movement of the earth
auger. Do not allow long
hair, loose fitting
clothing, or jewelry to be
around moving and/or
rotating parts.
To Next Page
Loading...
